Using Jaw Viewer
Landmarks and analysis
Landmarks are named points on the scan. They set the head position and feed the angles an analysis reports.
Place and check the points
- Open your scan in Measure and choose the landmark controls.
- Choose a guided set and read the prompt for the next point.
- Place the point in the slices and check it from the other directions before you go on.
A point that looks right in one view can be off in another. Check all three.
Check the head position
The head position says which way is up, forward and left. It comes from the landmarks you placed or from an automatic first guess. Check the fit and any residuals the viewer shows before you compare angles.
Read a calculated result
The analysis controls list the calculations available for your landmark set. Missing points have to be placed before their result appears.
Look at the points behind an angle that surprises you. A reference value is not a diagnosis and not a target for your own face. The analysis names its source and the population it was measured on; discuss what it means with your clinician.